- GASTEC手動氣體采樣...
- GASTEC氣體檢測管
- GASTEC長時間（時量...
- GASTEC電泵用氣體檢...
- 日本光明（北川式）氣體檢...
- 日本KOMYOKK手動氣...
- 自動氣體采樣器
- 突發性有毒有害氣體檢測箱
- 惡臭氣體快速檢測箱
- 煙道氣體快速檢測箱
- 快速水質檢測管
- 快速水質、地質污染**檢...
- 便攜式氣體報警器
- 恩尼克思?xì)怏w檢測報警器
- 壓縮空氣有害不純物檢測套...
- 標準氣體發生裝置
- 室內空氣質量檢測儀
- 特殊用檢測管
- 國產氣體檢測管及采樣器
- 便攜式氣味傳感器
- 氣體采樣袋
- 配件及耗材
- 氣體傳感器
產品詳情
簡單介紹：
日本北川式總烴氣體檢測管187S
日本北川式總烴氣體檢測管187S，總烴氣體檢測管187S GENERAL HYDROCARBONS 50-1400ppm，日本光明理化工業株式會社從1947年開始，在氣體分析領域開拓了六十余年 , 形成了馳名于世的 ” 北川 ” 式氣體檢測管。
詳情介紹：
日本北川式總烴氣體檢測管187S
日本北川式總烴氣體檢測管187S，總烴氣體檢測管187S GENERAL HYDROCARBONS 50-1400ppm，日本光明理化工業株式會社從1947年開始，在氣體分析領域開拓了六十余年 , 形成了馳名于世的 ” 北川 ” 式氣體檢測管。氣體快速分析法 ” 北川 ” 的歷史就是日本檢測管的歷史 。目前是世界上*大的檢測管生產廠家，也是日本**家通過美國SEI的認證，歐盟的認證的檢測管廠家。公司不僅有ISO9001:2000的認證，還獲得了環境管理的ISO14001的認證。北川式手動氣體采集器AP-20 備有采氣完成指示計 , 可以清楚的判明采氣是否完成 . • 有專門截留玻璃的截留槽 , 以防止檢測管割尖時玻璃片飛濺 . • 有采氣容積為 50 毫升和 100 毫升的兩段式制動卡 . • 采氣器極為小巧 , 并有便于攜帶的皮具包 。
Tube No.
137
1. PERFORMANCE
1) Measuring range ：50-1,400 ppm(as n-Hexane)
Number of pump strokes 1(100ml)
2 pump strokes(200ml)are required for Kerosine and Mineral tupentine
determination.
2) Sampling time ：1.5 minutes/1 pump stroke
3) Detectable limit ：5 ppm
4) Shelf life ：2 years
5) Operating temperature ：0～40℃
6) Temperature compensation ：Necessary(refer to "Table 2. Temperature CorrectionTable")
7) Reading ：Direct reading from the scale calibrated by 1 pump stroke
8) Colour change ：Orange→Yellowish green
2. RELATIVE STANDARD DEVIATION
RSD-low：10％ RSD-mid.：5％ RSD-high：5％(Controlled on n-Hexane)
3. CHEMICAL REACTION
Chromium oxide is reduced.
CH3(CH2)4CH3＋Cr6＋＋H2SO4→Cr3＋
4. CALIBRATION OF THE TUBE
GAS CHROMATOGRAPHY
5. INTERFERENCE AND CROSS SENSITIVITY
GAS To pump
1400
1200
1000
800
600
400
200
100
50
ppm
????
187S GENERAL HYDROCARBONS
Substance Interference Coexistence
The bottom of the discoloured
Aromatic hydrocarbons layer is changed to Black and
higher readings are given.
It has no influence on readings even if Alcohols, Esters or Ketones each co-exists up to 6％.
(NOTE)
1)Determine the concentration of objective gas by multiplication with the figure shown in Table 1 after
temperature correction.
Example)For measuring Heptane at 10℃ of temperature
Reading concentration ：600 ppm
Concentration on temperature correction ：660 ppm
Concentration of Heptane ：990 ppm
Table.2 Temperature Correction Table (20℃standard)
Readings 0℃ 10℃ 20℃ 30℃ 40℃
1400 1630 1530 1400 1270 1180
1200 1400 1320 1200 1090 1010
1000 1170 1100 1000 910 840
800 930 870 800 720 670
600 700 660 600 550 500
400 460 430 400 360 330
200 220 210 200 180 170
100 100 100 100 100 100
Unit：ppm
Name of Gas Figure Name of Gas Figure
Isobutane 0.8 Heptane 1.5
Pentane 0.8 Octane 2.0
n-Hexane 1.0 Cyclohexane 1.0
Table.1 Coefficient Chart
137
1. PERFORMANCE
1) Measuring range ：50-1,400 ppm(as n-Hexane)
Number of pump strokes 1(100ml)
2 pump strokes(200ml)are required for Kerosine and Mineral tupentine
determination.
2) Sampling time ：1.5 minutes/1 pump stroke
3) Detectable limit ：5 ppm
4) Shelf life ：2 years
5) Operating temperature ：0～40℃
6) Temperature compensation ：Necessary(refer to "Table 2. Temperature CorrectionTable")
7) Reading ：Direct reading from the scale calibrated by 1 pump stroke
8) Colour change ：Orange→Yellowish green
2. RELATIVE STANDARD DEVIATION
RSD-low：10％ RSD-mid.：5％ RSD-high：5％(Controlled on n-Hexane)
3. CHEMICAL REACTION
Chromium oxide is reduced.
CH3(CH2)4CH3＋Cr6＋＋H2SO4→Cr3＋
4. CALIBRATION OF THE TUBE
GAS CHROMATOGRAPHY
5. INTERFERENCE AND CROSS SENSITIVITY
GAS To pump
1400
1200
1000
800
600
400
200
100
50
ppm
????
187S GENERAL HYDROCARBONS
Substance Interference Coexistence
The bottom of the discoloured
Aromatic hydrocarbons layer is changed to Black and
higher readings are given.
It has no influence on readings even if Alcohols, Esters or Ketones each co-exists up to 6％.
(NOTE)
1)Determine the concentration of objective gas by multiplication with the figure shown in Table 1 after
temperature correction.
Example)For measuring Heptane at 10℃ of temperature
Reading concentration ：600 ppm
Concentration on temperature correction ：660 ppm
Concentration of Heptane ：990 ppm
Table.2 Temperature Correction Table (20℃standard)
Readings 0℃ 10℃ 20℃ 30℃ 40℃
1400 1630 1530 1400 1270 1180
1200 1400 1320 1200 1090 1010
1000 1170 1100 1000 910 840
800 930 870 800 720 670
600 700 660 600 550 500
400 460 430 400 360 330
200 220 210 200 180 170
100 100 100 100 100 100
Unit：ppm
Name of Gas Figure Name of Gas Figure
Isobutane 0.8 Heptane 1.5
Pentane 0.8 Octane 2.0
n-Hexane 1.0 Cyclohexane 1.0
Table.1 Coefficient Chart